搜索产品
搜索文章
Advantech BB-SR30808115-SWH is a SmartFlex, AUS/NZ, 5x Ethernet, PoE PSE, Plastic, International Power Supply (EU, US, UK, AUS)
如需帮助,请联系我们
免费电话：400-880-8951
公司邮箱：advavee@outlook.com
咨询客服：一站式采购
批量采购定制咨询，请发送您的需求，我们将立即回复。
HW SPECIFICATIONS
| PORTS, LED, ANTENNAS | ||
| Up to 5x ETH ports | RJ45, 10/100 Mbps | |
| SIM | 2 Mini SIMs (2FF) (rear panel) | |
| LED Indicators | PWR, DAT, WAN, ETH, SIM, USR, POE, IN0, IN1, OUT | |
| 3x ANT - ANT, DIV, GPS
(sold separately) |
SMA connectors | |
| Wi-Fi Antenna (sold separately) | R-SMA connector | |
| USB | USB Host connector 2.0 | |
| SD Card | 1x Micro SD Card slot (rear panel) | |
| RST | RESET button (rear panel) | |
| *Optional 3-port SWITCH | 3x RJ45, 10/100 Mbps | |
| *Optional ETH - R232 - RS485 | RJ45, 4-pin terminal block, 3-pin terminal block connectors – Isolation up to 2.5 kV | |
| *Optional RS232 - RS485 | 5-pin terminal block, 4-pin terminal block connectors – Isolation up to 2.5 kV | |
| *Optional PoE PSE or PoE PD on ETH0 and ETH1 |
|
|
| POWER | |
| Power Supply (sold separately) | 10 – 60 VDC (2–Way Molex connector |
|
Power Consumption |
Idle: 2.5 W
Average: 4 W Peak: 11 W Sleep Mode: 10mW |
| ENVIRONMENTAL | |
| Temperature Range | Operating: -40 to +75 °C
Storage: -40 to +85 °C |
| Humidity | Operating: 0 to 95 %
Storage (Non-condensing): 0 to 95 % |
| Cold Start | -40 °C |
| Operating Altitude | 2000 m / 70 kPa |
| Ingress Protection Rating | IP30 |
| MECHANICAL | |
| Plastic or metal case with plastic or metal DIN rail | |
| Enclosure Dimensions | 55x97x125 mm |
| Weight Plastic | 170 g |
| Weight Metal | 375 g |
| OTHER TECHNICAL PARAMETERS | |
| CPU Power | 2 DMIPS per MHz |
| Flash memory | 256 MB |
| RAM | 512 MB |
| M-RAM | 128 kB |
|
PoE parameters |
PoE PD
parameters for opposite PSE |
PoE PSE |
| Input voltage range | 42.5 – 57 V | 44 – 57 V, 65 W |
| Power available | 25.50 W | 2x 25.50 W (ETH0, ETH1) |
| Maximum current | 600 mA | |
| Insul. Strength | 1.5 kV from the router | none |
| Standards IEEE 802.3at-2009 (PoE+) and IEEE 802.3af-2003 (PoE) supported. Cabling needed is Category 5, up to 12.5 Ω. It is possible to use a passive PoE injector | ||
| WI-FI - 802.11 A/B/G/N, AP OR CLIENT MODES | |
| Supported Wi-Fi band | 2.4 GHz, 5 GHz |
| Encryption | None, WEP, TKIP, AES |
| 5 GHz supported channels | 36, 40, 44, 48, 52, 56, 60, 64, 149, 153, 157, 161, 165 |
| 2.4 GHz supported channels | 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14 |
| Number of clients | 10 |
| Authentication | Open, Shared, WPA–PSK, WPA2–PSK |
| GNSS SPECIFICATIONS | |
| Antenna | 50 Ohms – active |
| Protocols | NMEA 0183 v3.0 |
| Frequency | Frequency |
|
Sensitivity |
Tracking: -161dBm
Acquisition (Assisted): -158dBm Acquisition (Standalone): -145dBm |
|
Acquisition time |
Hot start: 2.5 s Warm start: 26 s Cold start: 35 s |
|
Accuracy |
Horizontal: < 2m (50 %); < 5m (90 %) Altitude: < 4m (50 %); < 8m (90 %) Velocity: < 0.2mps |
HW SPECIFICATIONS
| CELLULAR MODULE PARAMETERS | |
| LTE parameters | LTE: Cat.4, 3GPP E-UTRA Release 11
FDD frequencies: 700 MHz (B28), 850 MHz (B5), 900 MHz (B8), 1700 MHz (B4), 1800 MHz (B3), 1900 MHz (B2), 2100 MHz (B1), 2600 MHz (B7) TDD frequencies: 2300 MHz (B40) LTE FDD bit rates: 150 Mbps (DL) / 50 Mbps (UL) LTE TDD bit rates: 130 Mbps (DL) / 35 Mbps (UL) Supported bandwidths: 1.4 MHz, 3 MHz, 5 MHz, 10 MHz, 15 MHz, 20 MHz |
| HSPA+ parameters | HSPA: 3GPP R8 DC-HSPA+
Supported frequencies: 850 MHz, 900 MHz, 1900 MHz, 2100 MHz Bit rates: 42 Mbps (DL) / 5.76 Mbps (UL) |
| UMTS parameters | Supported frequencies: 850 MHz, 900 MHz, 1900 MHz, 2100 MHz
Bit rates: 384 kbps (DL) / 384 kbps (UL) |
| TD-SCDMA parameters | Supported frequencies: 850 MHz, 900 MHz, 1900 MHz, 2100 MHz
Bit rates: 384 kbps (DL) / 384 kbps (UL) |
| EDGE parameters | Supported frequencies: 800MHz, 900 MHz, 1800 MHz, 1900MHz
Data throughput: max. 236.8 kbps |
| GPRS parameters | Supported frequencies: 800MHz, 900 MHz, 1800 MHz, 1900MHz
Data throughput: max. 85.6 kbps |
STANDARDS AND REGULATIONS
| SR308 | INDUSTRY CERTIFICATIONS & APPROVALS |
| Telecom and emission | RCM (Australia, New Zealand) |
| EMC | IEC 61000-6-2:2005, IEC 61000-6-3:2006 |
| Safety | EN 60950-1:2006 + A11:2009 + A1:2010 + A12:2011 + A2:2013, EN 62311:2008 |
SW SPECIFICATIONS
| SOFTWARE | |
| Network and Routing | DHCP Server, , DHCP Client, NAT/PAT, VRRP, Dynamic DNS client, DNS proxy, VLAN, QoS, NTP Client/ Server, IGMP, BGP, OSPF, RIP, SMTP, SMTPS, SNMP v1/ v2c/ v3, Backup routes, PPP, PPPoE, SSL, Port Forwarding, Host Port Routing, Ethernet Bridging |
| Security | HTTPS, SSH, VPN tunnels, SFTP, Firewall (IP Filtering, MAC address filtering, Inbound and outbound Port filtering), DMZ (via iptables) |
| VPN Tunnelling | Open VPN client and server and P2P, L2TP, PPTP, GRE, EasyVPN, DMVPN, IPSec with IKEv1 and IKEv2 |
| Configuration | Web server, SSH, Four configuration switchable profiles, Automatic configuration update from server Backup configuration, Restore configuration |
| Firmware Management | Automatic firmware update from server, Locally via LAN and USB or remotely OTA (HTTP, HTTPS), Over-the-Air software updates, Over-the-Air cellular module update from FW |
| Diagnostic | One CLICK report – current configuration / factory identification / system log / kernel log / reboot log / routing table, Remote diagnostics possible via SSH |
| Status | Network Status, DHCP Status, IPSec Status, Statistics history for last 60 days |
| Log | System Log, Reboot Log, Kernel Log |
| Controlling and Diagnostic | SMS, SNMP v1/v2c/v3, Statuses, Log |
| Event Engine | StartUp script & Up/Down script (Bash), Digital Input, Network Parameters, Data Usage, Timer, Power, Device Temperature Report Types: SMS, email, SNMP Trap |
| Other | IPv6 support |
ACCESSORIES
| INCLUDED IN PACKAGE | INCLUDED IN SET PACKAGE | SOLD SEPARATELY | ||
| ORDER CODE | DESCRIPTION | |||
| BB-TG.30.8113 | Antenna LTE, Terminal | a | a | |
| BB-GA.110.101111 | Antenna LTE, Magnet Mount | a | ||
| BB-AW-A2458G-FSRPK | Antenna Wi-Fi, 2.4 & 5 GHz | a | a | |
| BB-RPS-v3-MO2-M | SmartFlex Power Supply, 12V/1A | a | a | |
| BB-RPS-v3-PSE | SmartFlex Power Supply, 48V/1.35A (power cord required) | a | ||
| BB-PWRCORD-US | USA - Power Supply Power Cord | a | a | |
| BB-PWRCORD-EU | EU - Power Supply Power Cord | a | a | |
| BB-PWRCORD-UK | UK - Power Supply Power Cord | a | a | |
| BB-PWRCORD-AUS | AU - Power Supply Power Cord | a | a | |
| BB-SBD40 | DIN Rail Clip - metal | a | a | a |
| BB-CPD3 | DIN Rail Clip - plastic | a | a | a |
| BB-KN-v3-MO2-3 | PS Cable 2-wire, MO 2 pins, 3m, v3 routers | a | a | |
| BB-KIO-v3-MO6-3 | IO Cable 6-wire, 3m, v3 routers | a | ||
| BB-KD-ETH | Ethernet cable 1.5m | a | a | |
| Quick Start Guide | a | a |
BB-SR30808115-SWH我们网站向用户提供的cookie来增强您的用户体验，个性化内容，并向您展示有关我们优质产品的更多相关内容。
如果您同意我们使用cookie，请点击“接受所有cookie”。
或者，点击“管理cookie”以了解更多关于我们的隐私和cookie通知的信息，并选择您希望我们使用的cookie类型。
