BB-LD3IC-S

Specifications

Supported Vehicles

• OBDII Streamer supports any 2008 or newer light-duty vehicles that comply with the SAE J1979 OBDII specification

Supported Vehicle Interfaces

• ISO 15765, LSGMLAN, Ford Secondary CAN

Supported Parameters

■    Vehicle Identification Number

• Vehicle Speed Monitor aggressive driving
• Engine Speed Monitor idle time and engine abuse
• Engine Runtime Monitor activity, schedule maintenance

■    Throttle Position

• Odometer/Distance Traveled Monitor trip distance and HOS

■    Instantaneous Fuel Rate Usage per Hour

• Total Fuel Monitor MPG and protect against theft
• Ignition Status Track idle time
• Battery Voltage Watch for charging system failures
• PTO Status Automatically calculate fuel tax savings

■    Diagnostic Trouble Codes

• MIL Status
• Emissions Readiness Monitors Check remotely if vehicles are

ready for emissions certification

• Brake Switch Status Available on most Ford & GM

& Seatbelt Fastened                    trucks/vans Other parameters available on a custom basis.

Additional Features

• Ignition-On Signal Output RS-232 CTS/DB9 Pin 6
• Automatic low-power mode senses When vehicle speed & engine speed is

zero

• Automatic disconnect When technician scan tool is connected

■    Proprietary vehicle detection algorithm and embedded database

lets the same hardware work on all compliant vehicles

• Configurable parameter reporting By polling, at a fixed rate, or when a

threshold is exceeded

• Wide Operating Temperature -40 to +85 °C (-40 to +185 °F)
• Low Power Consumption 20W in Operating Mode 0.15W in Automatic Sleep Mode (Key Off)
• Enclosure Dimensions 6 x 48.3 x 25.4 mm
• Integrated Y-Cable J1962/ISO 15031 Type B
• Operating Voltage Range 8 to 30 V DC
• Form Factors Available Device, embedded software

Compliances

• Radiated RF Interference SAE J1113/41
• Load Dump and Transient Protection SAE J1113/11
• ESD Immunity SAE J1113/13

• Temperature Test Ten (10) temperature cycles as follows with unit operating normally
  1. Room (+25 °C) to Tmin in 15
  2. Soak at Tmin 1 Hour with power removed from
  3. Start unit at Tmin, confirm successful start by executing a command/response. Power-down Maintain unit unpowered for one minute between power-ups.
  4. Repeat Step 3 three
  5. Start unit at Tmin and ramp Tmin to Tmax in 30
  6. Operate at Tmax for 1
  7. Ramp Tmax to Tmin in 15
  8. Repeat Steps 1 through 7 nine times for a total of 10 cycles:
     1. 5 cycles at Vmin input
     2. 5 cycles at Vmax input

Vibration Testing

• IEC 60068-2-6 10 sweeps of 10 to 500 to 10Hz at rate 5 oct/min.

each axis.

Level to be 10 to 36Hz, 0.06 in DA 36 to 500Hz, 4g’s. Unit must remain operational during and after the test.

Shock Testing

• IEC 60068-2-27 18 to 50g’s, 11ms, ½ sine pulses, 3 each direction

each axis.

Unit must remain operational during and after the test.

Drop Testing

• IEC 60068-2-32 10 Freefall drops from 1 meter onto concrete

Drop 1 time one each face (6), 1 on a corner and the 3 edges of this corner.

The drop unit shall return to normal operation without physical damage.

Ordering Information

• BB-LD3IC-S Telematics OBDII Data Converter